Test

When you are done setting up the connector for Domino or Exchange, you can run an automatic test to see if everything is set up correctly.

When you click Test connection, the following window appears:

You can now test a full synchronization cycle with the user you enter in the Username field.

Performing an automatic test

1. Select the functions you want to test using the current connector. Only select the functions that the connector is meant to service. Select a combination of E-mail, Contacts, Calendar, and Tasks and to-dos.
2. Enter the name of a user you know should be serviced by the connector. If no users exist in DME yet, you must create one manually first. The user created must exist in the LDAP/AD directory of the connector.
3. Enter the password of the user you are testing for in the Password field.
4. Click Test.

DME now runs a test for each function by attempting to make a synchronization. A dummy device is created for the indicated user, and a full synchronization cycle is run for each function. The result of the diagnostic is shown in the window:

If any errors have occurred, they will be clearly marked in the window, and will also appear in the log. Any creates, deletes, and updates caused by the synchronization are rolled back immediately in any case, and the dummy device is deleted.

Click Back to perform another test, or Cancel if you are done.